Setup data in this installation

This demonstration installation was configured with uniform setup data to make testing easier. It resembles a lab specialising in animal feeds, complimented with a few water analyses. If not edited in the mean time by test users, the following are consistent:

This is a test set up

Analysis Services

Expected turnaround time (TAT) of 2 hours

Price of R10

Maximum duplicate variation 10%

Uncertainties (Range minimum, maximum,

Between 0 and 2, uncertainty value of ± 0.1

" 2.01 - 4.00, ± 0.2

" 4.01 - 6.00, ± 0.3

" 6.01 - 8.00, ± 0.4

" 8.01 - 999, ± 0.5

Analysis Specifications

All Sample Types: minimum 9, maximum 11, tolerance 10%

Analysis Profiles

Trace Metals

Ca, Cu, Fe, Mg, Mn, Na and Zn

Digestable Energy

Digestable Energy, Crude Protein, Ether Extract, Crude Fat and Ash

Micro-Bio

Clostridia, Ecoli, Salmonella and Enterococcus

Worksheet Templates

A few 10 position Worksheet templates were set up - always with

a Blank in position 1,
a Reference sample in position 2
and the Sample in position 10 being a duplicate of that in position 3

Calculations

A number of popular results calculations have been pre-configured in the setup

They include nutrient calculations for

Apparent Metabolisable Energy
Digestible Energy
Metabolisable Energy
Non-Structural Carbohydrates and
Total Digestible Nutrients.

Others are: Dry Matter results calculations and Residual Weight, Residual Weight (tare), Weight Loss, Weight Loss (tare) and Titration

Reference Definitions

1 Blank was configured with all analyses included with
Expected value of 0, minimum allowed of 0 and maximum of 1.

Any result outside of this range should raise an exception.

Other Reference Definitions are Feeds, Trace metals and Microbiology with
Expected values of 10, 10% deviation allowed = minimum 9, maximum 11